Safety Reminders - Labconco SteamScrubber 4010010 Series User Manual

replenished as needed. An alert will be displayed when Rinse Aid level is low and needs
refilled. To fill the neutralizing acid dispenser, refer to the Fig. 7-3 above and follow the
instructions below.
1. Raise the Rinse Aid Door on the Detergent Dispenser.
2. Fill the cavity with LabSolutions Neutralizing Acid Rinse (Catalog 4522200) until
the level of the liquid rises and is visible in the port.
3. Close the door.

Safety Reminders

Review the following safety reminders regularly with all personnel working with the
Glassware Washer. Failure to abide by these precautions may result in damage to the
washer, your glassware or bodily harm to the user.
Do not use combustible solvents in the Glassware Washer. If soiled glassware
contains flammable compounds, rinse the glassware thoroughly prior to placing
the glassware into the washer. Heaters in the washer are very hot and could
ignite flammable solvents.
Petroleum based compounds and some strong acids may degrade certain
internal washer components. Always thoroughly rinse all glassware before
placing in the Washer.
Pay attention to the warning labels on the Glassware Washer door. They warn of
hot steam and/or surfaces, and flammable solvents are prohibited. See Fig. 7-4.
Do NOT use foaming detergents, or any soap, surfactant or detergent not
specially formulated for use in glassware washers. Failure to abide by this
specification may result in water/detergent over spilling the door seal and
damaging the washer and/or the facility and is not covered by warranty.
78
Figure 7-4