Verification - Labconco SteamScrubber 4010010 Series User Manual

 The component selected will activate and test the low voltage components to
verify their operation.
 Confirm that all tested components passed.
 Scroll up to Fill All The Way, select and confirm. The washer will fill to set point
with hot water. When complete, the water level should touch but not cover the
heaters. If necessary, the test can be stopped by selecting Fill All The Way again
and confirming.
 Once the tank is full of water, make sure the door is closed, select and confirm
Wash Pump. The wash pump should spin up for approximately 10 seconds.
 Select Drain All the Way and confirm. The washer should drain for approximately
3 minutes.

Verification

Once the diagnostic tests are complete, scroll through the status of each line item to
verify that it passed the tests.
If there are any failures refer to
determining root cause and corrective action.
Section 10: Troubleshooting
34
for assistance in