About Tab; Analyze; Tool Tab - Stanley Theta Controller User Manual

Table of Contents

Theta Controller

Controller Tab Screens

Analyze Screens

Analyze displays tool and controller diagnostic information, traces and I/O status.

Transducer Health – The thickness of the vertical line within the horizontal bar indicates

transducer signal (a thicker line means more load is applied). The line should be thin when no

load is applied to the tool. This indicates the zero point of the transducer. Once the zero point

of the line reaches the tick mark, on either side of center, the transducer needs to be replaced.

Transducer Torque – Provides a live transducer torque value during the tightening cycle.

Transducer Current – The transducer is powered with a constant current value. This current

should be present and not varying. See section 1.3 Specifications, Layout and Display for

limits.

Controller DC Bus voltage – The bus should always be around 320 VDC. The minimum is

285 VDC and the maximum is 400 VDC.

Controller AC Supply Voltage / Frequency – See section 1.3 Specifications, Layout and

Display for controller AC volts specification.

Tool Temperature – Temperature is not measured during tool operation. Interacts with the

Temperature Limit parameter. See section 2.8.3.7 Tool Tab for further information.

Tool Output Angle – Identifies number of circular degrees of rotation on the output of the tool.

Resets at each start.

Tool Output Speed – Real time speed of the output of the tool.

Programming

Options Screen

2.8.5.3.1 About Tab

This tab displays information about the

controller. These values are read only unless

blank. The Model and Serial fields can be

written to once.

Options Screen

2.8.6.1

Use this tab to perform diagnostics during

troubleshooting operations. This tab shows

live status of the following events:

Table of Contents