Table of Contents
Advertisement
Theta Controller Connections
Each controller or Theta Controller has a different combination of connectors. These connectors
serve several purposes, such as:
•
Power
•
Tool Connections
•
Discrete inputs and outputs
•
Communications
POTENTIAL ELECTROSTATIC DISCHARGE HAZARD AND WATER AND DIRT INGESTION
To Avoid Damage:
If not using a connector, keep the connector securely covered with the provided cap. This reduces
the opportunity for transfer of static electricity and prevents dirt and water from entering the
controller.
4.1 Theta Controller Connections
4.1.1 Theta Controller Power Cord
Theta Controllers use an IEC 60320 style connector. The power source connector for the power
cord is based on customer requirements. The power cord should be rated at either 15A/125V for
115 V or 10A/250V for 230 V use of the controller.
4.1.2 Theta Controller Tool Connector
Theta controllers use a single 30-pin connector to connect the EC series QPM DC electric tool
cables. QPM EC DC electric tool cables use a MIL-C-38999 Series III connector. The connector is
a 17-30S with the insert having a B clocking position (30-pin Tool Connector).
46
C A U T I O N
30-pin Tool Connector
User Manual
Advertisement
Table of Contents
