Table of Contents
Advertisement
Theta Controller
2.8.1.3 Setup: Manage Button (Job)
Manage Button (Job) Screens
Manage enables active job settings to be added, deleted, and/or copied to the clipboard and
pasted.
Add – Adds a Job to the controller. If a tool is attached, the Wizard begins for easy setup of
Job parameters. If a tool is not attached the Jobs tab appears for manual parameter setup.
Jobs do not have to be added sequentially. A Job can be added before or after the one that is
selected. Jobs renumber automatically after being added. Make a selection and press OK to add
a Job, or CANCEL to not add a Job.
Delete – Deletes the selected Job from the controller. Jobs cannot be recovered once deleted.
Copy – Copies the selected Job and its associated Tasks and Steps to the Clipboard.
Paste – Overwrites the selected Job with the values residing in the Clipboard.
To move a Job: first create a new one where it is needed, next copy the Job to be moved, then
paste it into the new one created and finally delete the original.
Press the EXIT interactive menu button to save changes and return to the Run screen. See
section 2.8.1.7 Setup: Exit for further information.
2.8.1.4
Setup: Task Button
Task Tab Screens
Task settings apply to all Steps inside the Task.
Programming
Options Screen
Options Screens
Select Tasks by pressing the TASK
interactive menu button.
19
Advertisement
Table of Contents
