Stanley Theta Controller User Manual page 22

Job Tab Screens
input to select the Task to run within a Job.
Auto Reset Job – Yes resets the Job automatically after the Batch Count has been met. The tool
will not disable with Error Proofing enabled. No requires an Input or Trigger to Reset the Job.
The tool disables with Error Proofing enabled. If Error Proofing is disabled, the tool is always
enabled but will not count higher than the Batch Count value.
Enable Error Proofing – Yes causes the tool to disable after the accumulated fastener count
equals the target fastener count for the job, unless Auto Reset Job is set to Yes. A Trigger or
Input is required to Reset the Job and set the accumulated count to zero. Yes also enables more
parameters that will dynamically appear on the screen, see below. No keeps the tool enabled
even after the Job's target count is met. The count will not increase beyond the target value. No
will not cause new parameters to appear.
Disable Disassembly – This section identifies whether the tool removes the Disassembly
(Reverse) function on one of the following events:
On Cycle OK – Yes does not allow the use of Disassembly mode after each OK
fastening cycle. The tool can only be used to back out fasteners after a NOK fastening
cycle. No allows the use of Disassembly mode after any fastening cycle unless the
logic of the other two events is met.
On Job Complete – Yes does not allow the use of Disassembly mode after the active
Job is complete (accumulated count equals target count). No allows the use of
Disassembly mode after a Job is complete unless the logic of the other two events is
met.
On All Fasteners Removed – Yes does not allow the use of Disassembly mode after
all fasteners have been removed (i.e., accumulated count is back to zero). No allows
the use of Disassembly mode after all fasteners have been removed unless the logic of
the other two events is met.
Disable Assembly – This identifies whether the tool disables after each Task has
completed. This requires a Reset Job, Task Select or Task Select Bit input to select an
incomplete Task which enables the tool for an incomplete Task only. If Auto Sequence
Task is used, the tool re-enables when the active Task switches to an incomplete Task.
On Task Complete – Yes disables the tool when the active Task is complete. If an
input switches the controller to a completed Task, the tool disables. No will not
disable the tool when the active Task is complete.
Press the EXIT interactive menu button to save changes and return to the Run screen. See
2.8.1.7 Setup: Exit for further information.
Press the MANAGE interactive menu button to Add, Delete, Copy or Paste Jobs. See section
2.8.1.3 Setup: Manage Button (Job) for further information.
Press the TASK interactive menu button to setup the parameters of the Tasks and Step(s) inside
the selected Job. See section 2.8.1.4 Setup: Task Button for further information.
18
User Manual
Options Screens