I/O Tab; Output Bus - Stanley Theta Controller User Manual

Other Screens
Use the right arrow to move to the next tab or press EXIT to save the changes and return to the
Run screen. See section 2.8.1.7 Setup: Exit for further information.
Use the right arrow to move to the next tab or press EXIT to save the changes and return to the
Run screen. See section 2.8.1.7 Setup: Exit for further information.
28
Options Screen
2.8.3.3

I/O Tab

This is the place to assign elements to the
controller's Inputs and Outputs. Select the bus
that requires assigning by pressing the BUS
interactive menu button.
Use the Up/Down arrow keys to select the bus
then press the OK interactive menu button.
Once the bus is selected, then the individual
pins can be assigned.

2.8.3.3.1 Output Bus

The 24 VDC connector has pins 7 through 14
designated as Outputs from the controller.
The pin assignments are selectable on this tab.
Use the up/down arrows to select the pin to
assign, then press the Toggle button or the
EDIT interactive menu button. A list of
available output elements displays. See
section 4.2 Assignable Input/Output
Functions for a complete list and descriptions.
Highlight an element to assign to the selected
pin and press the NEXT interactive menu
button.
An Output element can be assigned to more
than one pin. See section 4.2 Assignable
Input/Output Functions for configuration
options and descriptions.
Configure the selected output element. After
modifying press the FINISH interactive menu
button.
User Manual