Analyze Area; Tool Tab - Stanley QB Expert Instruction Manual

3.2.2.1.1 UPDATE Button
This button is used to update the firmware in the Alpha controller.
Download a software BIN file from the Internet and transfer it to a USB memory stick. Insert the USB memory
stick into the USB port on the bottom of the Alpha controller. Scroll to the binary file provided and then press the
OK interactive menu button.
The "Update Controller Firmware" screen appears to confirm the action. Press YES to continue with the update.
Press NO to cancel the update.
A progress bar on the bottom of the screen indicates the file transfer status from the USB memory stick to the
Alpha controller memory.
When the file transfer is complete, the "Cycle power to complete the update" window appears indicating it is time
to reboot the controller to complete the upgrade. Turn off the controller, remove the USB memory stick, wait 20
seconds, then turn on the controller.
After the controller starts, it checks that the file is complete and written to permanent memory. The controller
auto-reboots. When the run screen appears, the controller is updated and ready.
During the file transfer process, a file error can cause the transfer to abort and the error message appears. Contact
your STANLEY representative if this happens.
The "Invalid File" screen appears if the update file is for a different controller. Contact your STANLEY representative
if this happens.
Trailing controllers and QPM Cordless Tools that are connected to the Expert may also be updated this way by
simply choosing the spindle before selecting SERVICE > CONTROLLER. It is advised to update trailing controllers
and QPM Cordless Tools before updating the lead controller (Expert).
Press EXIT when finished.
3.3

ANALYZE Area

Analyze displays tool and controller diagnostic information, traces and I/O status.
Press the ANALYZE button to perform diagnostics on the controller, tool or I/O, look at fastening cycle traces,
perform Statistical Process Control analysis, or to download error log data.

3.3.1 TOOL Tab

This tab shows live status. It updates every millisecond. Use this tab to perform controller or tool diagnostics
Instruction Manual
Programming
79