Lights Tab; Tones Tab - Stanley Theta Controller User Manual

Other Screens
Use the right arrow to move to the next tab or press EXIT to save the changes and return to the
Run screen. See section 2.8.1.7 Setup: Exit for further information.
Use the right arrow to move to the next tab or press EXIT to save the changes and return to the
Run screen. See section 2.8.1.7 Setup: Exit for further information.
Use the right arrow to move to the next tab or press EXIT to save the changes and return to the
Run screen. See section 2.8.1.7 Setup: Exit for further information.
30
Options Screen
Any – Either the tool trigger or tool push-
to-start switch starts the tool.
All – Requires that both the tool trigger
and the tool push-to-start switch must be
activated to start the tool.
Lever – Only the trigger on the tool starts
the tool.
PTS – Only the push-to-start switch on the
tool starts the tool.
None – Neither the tool trigger nor the tool
push-to-start switch starts the tool.
2.8.3.5

Lights Tab

Sets the time the pistol tool headlights remain
on, in seconds, after the trigger is pressed.
2.8.3.6

Tones Tab

The alarm in the tool handle can emit
different tones based on the status of the
tightening cycle. Choose an Accept Tone for
an OK tightening cycle and a Reject Tone for
a NOK tightening cycle.
Play – Previews the tone selected.
Stop – Stops playing the tone selected.
User Manual