Table of Contents
Advertisement
Inputs
Description
STOP
When asserted, the controller stops the tool. It also keeps the tool from running while it is
applied.
When removed nothing happens other than the tool will be allowed to run.
The size of this input function is 1 bit.
Configuration:
Contact Type
SELECT
When asserted or removed the controller selects a tASK. This is one bit of a binary number
TASK (BIT)
created by several of these bits.
The size of this input function is 1 bit.
Configuration:
Contact Type
Bit: The operator assigned bit number for job selection (follows the operator's assigned
binary number scheme).
Mode: All SELECT TASK BITs must be the same mode, no mixing of modes allowed.
Binary – Creates a decimal number equivalent to the weighted value of this binary
bit(s).
Binary + 1 – Creates a number equivalent to the weighted value of this binary bit(s)
and adds the value of one (1) to that number.
SELECT JOB
When asserted or removed the controller selects a Job. This is one bit of a binary number
(BIT)
created by several of these bits.
The size of this input function is 1 bit.
Configuration:
Contact Type
Bit: The operator assigned bit number for job selection (follows the operator's assigned
binary number scheme).
Mode: All SELECT JOB BITs must be the same mode, no mixing of modes allowed.
Binary – Creates a decimal number equivalent to the weighted value of this binary
bit(s).
Binary + 1 – Creates a number equivalent to the weighted value of this binary bit(s)
and adds the value of one (1) to that number.
REVERSE
When asserted, the controller places the tool in Reverse (disassembly) mode. This will NOT
run the tool in Reverse; it simply changes the tool mode from Forward to Reverse.
When removed the controller returns to the tool to the Forward (assembly) mode.
The size of this input function is 1 bit.
Configuration:
Contact Type
When asserted on any input type, the controller sets an internal bit and waits for the active
SYNC IN
step to end. When the controller is synchronized, and this input is asserted, the SYNC OUT
output is asserted indicating to the next controller in line that all controllers upstream are
finished with the current step.
When removed nothing happens.
Size: 1 bit
Configuration:
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
When asserted on any input type, the controller turns off the SYNC OUT output and starts
RESUME
the next step in the multi-step strategy.
When removed nothing happens.
Size: 1 bit
Configuration:
Contact Type: Normally Open (N.O.), Normally Closed (N.C.)
52
User Manual
Advertisement
Table of Contents
