Tool Status Lights; Mfb Mode - Stanley QB Expert Instruction Manual

QPM Tool Controls and Operation
6

5.2.4 Tool Status Lights

Handheld tools from STANLEY ASSEMBLY TECHNOLOGIES have three (green, yellow, and red) status lights. The
status light mirror or copy the status lights on the controller.
Green
Yellow
Red
All lights Reverse

5.2.5 MFB Mode

The MFB Mode configures the multiple function button for handheld QPM tools. The button can be configured to
operate in any of the following modes.
Disable
Reverse
(Disassembly)
Job/Task Select
Arm
Reset Reject
110
1 4 2
7
Tightened to specified limits
Low torque or angle
High torque or angle
The button does nothing.
Pressing the button toggles between assembly and disassembly and illuminates the
appropriate blue light [1] or [2]. All tool status lights [3] and [7] flash when the tool is in
disassembly mode.
Pressing the button toggles between Job/Task 1 and Job/Task 2 and illuminates the
appropriate orange light [6] or [4].
Pressing the button arms (activates) the trigger but does not start the tool. The blue
assembly light [2] comes on to show that the tool is armed for three seconds.
This function, when selected, will cause the tool to disable after a NOK Fastening cycle.
The Reject Tone, when enabled, will sound. Pressing the button re-enables the tool
indicating the operator acknowledges the rejected Fastening cycle and wishes to repair it.
3
The Fastening cycle meets all of the specified parameters.
The Fastening cycle was rejected for not achieving either low
torque or low angle.
The Fastening cycle was rejected for exceeding either high torque
or high angle.
The next time the start trigger is engaged the tool will remove the
fastener.
QB Expert Alpha Controller
5