Off Timer; Energy Consumption; Power Consumption Limit; Setpoint Auto Reset - Daikin Madoka BRC1H519W7 Installer And User Reference Manual

15 | About the app

15.5.11 OFF timer

15.5.12 Energy consumption

15.5.13 Power consumption limit

15.5.14 Setpoint auto reset

Installer and user reference guide
106
INFORMATION
For systems in which the indoor units run in simultaneous operation, this function is
controlled by the motion sensor mounted in the master indoor unit.
Set a timer for the system to turn OFF automatically. The timer can be enabled or
disabled. When the timer is enabled, it starts running each time the system gets
turned ON.
The timer has a range of 30~180 minutes, and can be set in increments of 30
minutes.
See and compare energy consumption data.
INFORMATION
The availability of this function depends on the type of indoor unit.
INFORMATION
This function cannot be used when the indoor units are in group control.
INFORMATION
This function is not supported when the system contains Sky Air RR or RQ outdoor
units.
INFORMATION
The displayed energy consumption can be different from the actual energy
consumption. The displayed data is not the result of a kWh measurement, but the
result of a calculation based on measured operation data. Some of that operation
data are absolute values, but some are interpolations, including room for
interpolation tolerance.
Set a timespan in which the system limits its peak power consumption. When
enabled, this function makes the outdoor unit operate with limited energy
consumption (70% or 40% of usual consumption) in the set timespan.
INFORMATION
The availability of this function depends on the type of outdoor unit.
Set a timer for the system to automatically adjust the temperature to a set
temperature value. The timer can be enabled or disabled for Heating and Cooling
operation separately. When a timer is enabled, it starts running each time the
system gets turned ON. When the timer runs out, the temperature setpoint will
always change to the set value, also if the temperature setpoint has been changed
in the meanwhile.
BRC1H519W+K+S7
Madoka wired remote controller
4P513689-1E – 2020.12