15.5.8 About
15.5.9 Remove bonding information
15.5.10 Presence detection
BRC1H519W+K+S7
Madoka wired remote controller
4P513689-1E – 2020.12
INFORMATION
If the controller is disconnected from the power for more than 48 hours, the date
and the time need to be set again.
INFORMATION
The clock will maintain accuracy to within 30 seconds/month.
Read out the current remote controller and remote controller Bluetooth module
software version.
Make the controller forget all previously bonded mobile devices.
Set a timer for the system to adjust the temperature setpoint or to turn off
automatically, based on (the lack of) presence detected by a motion sensor.
Action
Auto OFF
Setpoint adjustment
INFORMATION
To use this function, it is required that the indoor units are equipped with a motion
sensor (optional accessory).
INFORMATION
This function cannot be used when the indoor units are controlled by a centralised
controller.
INFORMATION
This function is not supported when the system contains Sky Air RR or RQ outdoor
units.
INFORMATION
This function cannot be used when the indoor units are in group control.
15
About the app
|
Description
Set an OFF timer that starts running as
soon as the motion sensor detects the
room is unoccupied.
Set setpoint adjustment increments and
intervals for both heating and cooling
operation. When the motion sensor
detects the room is unoccupied, the
system will raise (cooling operation) or
lower (heating operation) the setpoint,
until the set limit is reached.
Installer and user reference guide
105