Program Timer Operation; Emergency Operation; Precautions For Group Control System Or Two Remote Control System - Daikin BRC082A41W Operation Manual

Program timer operation

Operate in the following order.
„ The timer is operated in the following two ways:
- Programming the stop time (
The system stops operating after the set time has
elapsed.
- Programming the start time (
The system starts operating after the set time has
elapsed.
„ The timer can be programmed for a maximum of 72 hours.
„ The start and the stop time can be simultaneously
programmed.
1
TIMER MODE START/STOP
Press the TIMER MODE START/STOP button several
times and select the mode on the display.
The display blinks.
- For setting the timer stop ....................................
- For setting the timer start ....................................
2
PROGRAMMING TIME
Press the TEMPERATURE SETTING button and set the
time for stopping or starting the system.
When this button is pressed, the time
advances by 1 hour.
UP
When this button is pressed, the time goes
backward by 1 hour.
DOWN
3
TIMER RESERVE
Press the TIMER RESERVE button.
- The timer setting procedure ends.
- The display changes from blinking light to a constant light.
4
TIMER CANCEL
Press the TIMER CANCEL button to cancel programming.
The display vanishes.
For example.
When the timer is
programmed to stop
the system after 3
hours and start the
system after 4 hours,
the system will stop
after 3 hours and
then 1 hour later the
system will start.
After the timer is programmed, the display
NOTE
shows the remaining time.
6
).
).
ON OFF
TEMP
TIME
F
UP
DOWN
FAN
RESERVE CANCEL
hr.
TIMER
hr.
MODE

Emergency operation

When the remote controller does not work due to battery
failure or the absence thereof, use the switch which is located
beside the discharge grille on the indoor unit.
When the remote controller does not work, contact your dealer.
1
START
Press the emergency operation switch.
„ The unit runs in the previous mode.
„ The system operates with the previously set air flow
direction.
2
STOP
Press the emergency operation switch again.
Precautions for group control system or
two remote control system
This system provides two other control systems beside
individual control (one remote controller controls one indoor
unit) system. Confirm the following if your unit is of the
following control system type:
„ Group control system
One remote controller controls up to 16 indoor units.
All indoor units are equally set.
„ Two remote controller control system
Two remote controllers control one indoor unit. (In case of
group control system, one group of indoor units.)
The unit follows individual operation.
„ Cannot have a two remote controller control
NOTE
system with only wireless remote controllers.
(It will be a two remote controller control
system having one wired remote controller
and one wireless remote controller.)
„ Under two remote controller control system,
wireless remote controller cannot control timer
operation.
„ Only the OPERATION lamp out of 3 other
lamps on the indoor unit display functions.
Contact your dealer in case of changing the
combination or setting of group control and two
remote controller control systems.
1•2
■
English