Daikin Madoka BRC1H519W7 Installer And User Reference Manual page 83

To set Cooling/Heating masterhood
BRC1H519W+K+S7
Madoka wired remote controller
4P513689-1E – 2020.12
The behaviour of this status icon is according to the following table:
If a controller displays ...
... NO status icon
... a CONSTANT status icon
... BLINKING status icon
Operation mode
The operation mode behaviour of the indoor units is according to the following
table:
If the master ...
... is set to "Heating", "Dry", or "Auto"
operation mode
... is set to "Cooling" operation mode
... is set to "Fan only" mode
Once an indoor unit is set as master, it can be released from masterhood. For
instructions, see "To release Cooling/Heating
unit/group into the master, first release the currently active master from its
masterhood.
INFORMATION
Ventilation mode changes are possible regardless of Cooling/Heating masterhood.
Prerequisite: No indoor unit is yet set as Cooling/Heating master ("changeover
under centralised control" icon blinking on all controllers).
Prerequisite: You are operating the controller of the indoor unit that you want to
set as Cooling/Heating master.
1 Navigate to the operation mode menu.
2 Set the operation mode to either Cooling or Heating.
Result: The indoor unit is now Cooling/Heating master ("changeover under
centralised control" icon not on controller).
Result: All slave controllers display the "changeover under centralised control"
icon.
14
|
Then ...
... The indoor unit connected to that
controller is Cooling/Heating master.
... The indoor unit connected to that
controller is slave to a Cooling/Heating
master.
... NO indoor unit is assigned as Cooling/
Heating master yet.
Then the slaves ...
... start running in the same operation
mode as the master. No other modes
are then available for them.
... then the slaves cannot run in
"Heating" operation mode, but can still
run in "Cooling", "Fan only" and "Dry"
operation mode.
... can ONLY run in "Fan only" mode.
4
masterhood" [ 84]. To turn a slave
Installer and user reference guide
Configuration
83