Connecting The Strobe - CyberData 011406 Operation Manual

2.2.5 Connecting the Strobe

1. Remove the three mounting screws to remove the AC panel cover. See
2. Insert the power cord and network cable through the rubber grommets at the bottom of the
3. Connect the power cord and ground wires to a 125VAC Outlet or universal receptacle on the
4. Connect a network cable to the power injector. See
Network Cable to Power Injector.
Network
Cable
Operations Guide
enclosure. See Figure 2-12.
back of the AC panel cover. See
Figure 2-12. Connecting the Strobe
Stripe & Tin Wires
0.4" [10mm]
AC PANEL COVER
Paging Amplifier Removed
to Show Cable Exit
Singlewire InformaCast Loudspeaker Amplifier (AC-Powered) Setup
Figure 2-12.
Figure
Power Cord
Network Cable
931281B
Connecting the Strobe
Figure 2-12.
2-12.
Rubber
Grommets
Note:
Power Cord and Network Cable are Not Included.
CyberData Corporation
16