CyberData 011406 Operation Manual page 58

2.3.7.2 Point-to-Point Configuration
When the device is set to not register with a SIP server (see
device to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The device can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 2-29. SIP Page Set to Point-to-Point Mode
Device is set to NOT register with a SiP server
931281B
Singlewire InformaCast Loudspeaker Amplifier (AC-Powered) Setup
Configure the SIP (Session Initiation Protocol) Parameters
Figure 2-29), it is possible to set the
CyberData Corporation
51