Setting The Time And Date; Setting The Language - Loma IQ3X Operating Instructions Manual

Operating Instructions

4.2 Setting the Time and Date

It is important that the correct time and date are set on the machine as they are used to time
stamp the data in the contaminant, fault and error logs and are shown on the reports. In addition
they determine the interval and synchronisation of automatically initiated PV tests.
The following procedures assume that the machine is switched on and working
normally and that you are logged into the machine with sufficient access rights to
access the Menus > Set Up > Calendar menu.
To change the time and date, proceed as follows:
1. Select Menus > Setup > Calendar to display the Calendar menu options.
2. Use the Navigation Keys
to enable the current value to be edited.
3. Use the Navigation Keys
Enter Key to confirm the selection.
4. Repeat steps 2 and 3 above to select the required values for the Month, Day, Date, Hours and
Minutes options.

4.3 Setting the Language

To set the system language, proceed as follows:
1. Select Menus > Service > Configuration > General to display the General menu options.
2. Use the Navigation Keys
Enter Key to enable the current value to be edited.
3. Use the Navigation Keys
OK / Enter Key to confirm the selection.
Copyright © Loma Systems
to select the Year option and press the OK / Enter Key
to select the required Year and then press the OK /
to select the Language option and press the OK /
to select the required Language and then press the
40
Original Document