Overland Storage PowerLoader User & Installation Manual page 79

6045 Command Overlap
Enter to Reboot or
Power Down to Clear
6046 No Pkts to Send
Enter to Reboot or
Power Down to Clear
6047 Invalid Direction
Enter to Reboot or
Power Down to Clear
6048 Master Pkt ID Bad
Enter to Reboot or
Power Down to Clear
6049 HDR CRC Error
Enter to Reboot or
Power Down to Clear
604A Data CRC Error
Enter to Reboot or
Power Down to Clear
604B Packet Length Error
Enter to Reboot or
Power Down to Clear
604C Slave Address Error
Enter to Reboot or
Power Down to Clear
8001 Bad Cartridge
Press Enter to Clear
8002 Drive preventing
Press Enter to Clear
8003 Unsupported Cart
Press Enter to Clear
8004 Update failure
Enter to Reboot or
Power Down to Clear
8005 Bad update tape
Press Enter to Clear
Table 5-2. Fault Symptom Codes
HARD fault - Command Overlap.
HARD fault - No Pkts to Send.
HARD fault - Invalid Direction.
HARD fault - Master Pkt ID Bad.
HARD fault - HDR CRC Error.
HARD fault - Data CRC Error.
HARD fault - Packet Length Error.
HARD fault - Slave Address Error.
SOFT fault - the drive was unable to seat the
cartridge on the chuck after multiple retries.
This may be due to a defective cartridge.
SOFT fault - An eject command has been
rejected by the drive because the drive is set
to prevent media removal.
SOFT fault - The drive has detected an
unsupported cartridge type was loaded and
has rejected it.
HARD fault - LTO drive reports bad flash
update.
SOFT fault - Drive update from tape has
been aborted due to a defective tape (bad
checksum).
F S C (FSC)
AULT YMPTOM ODES
C, D, G
C, D, G
C, D, G
C, D, G
C, D, G
C, D, G
C, D, G
C, D, G
F
F
F
C, D, G
F
t
Troubleshooting 5-17