Overland Storage PowerLoader User & Installation Manual page 68

F S C (FSC)
AULT YMPTOM ODES
1026
1027
1028
1029
1030
1050
1051
2001
2002
2003
2004
2005
u
5-6 Troubleshooting
Table 5-2. Fault Symptom Codes
Overlapped Ctl Msgs SOFT fault - the SCSI process received a new
Press Enter to Clear asynchronous message from the control
process before it had completed the handling
of the previous message.
Control Process Busy SOFT fault - thee control process is busy
executing a SCSI command.
Press Enter to Clear
Control Initializing SOFT fault - the control process is
initializing and cannot service the SCSI
Press Enter to Clear
command.
Control Seq. Mode SOFT fault - the library is in sequential
mode and cannot execute a move cartridge
Press Enter to Clear
command.
Invalid SCSI Id SOFT fault - the requested SCSI id was >= 8
while in narrow mode.
Press Enter to Clear
No Free ESP Packets SOFT fault - The SCSI process cannot get an
Press Enter to Clear available message structure for an
encapsulated SCSI packet.
No Free Tids SOFT fault - the SCSI process cannot get a
Press Enter to Clear transaction id because all id are currently in
use.
Ctl. Invalid The browser issued an unrecognized
Command command. This code is used only to report
the exception back to the Web TLC.
Press Enter to Clear
Undefined Config HARD fault - the loader configuration
jumpers were set for an invalid
Enter to Reboot or
configuration.
Power Down to Clear
Invalid Drive State The Web TLC attempted to unload an empty
drive. This code is used only to report the
Press Enter to Clear
exception back to the Web TLC.
Loader Not Ready The control process was not ready to accept
an incoming browser command. This code is
Press Enter to Clear
used only for reporting back to the Web TLC.
SCSI Id Not Set Used for reporting back to the Web TLC
when the loader was unable to change the
Press Enter to Clear
drive's SCSI id.
F
F
F
F
F
F
F
F
C, D, G
F
F
F