F
S
C
(FSC)
AULT
YMPTOM
ODES
4010
4011
4012
4013
4014
5001
5002
5003
5004
5010
5011
5012
5013
5014
u
5-12
Troubleshooting
Table 5-2. Fault Symptom Codes
Comm. Uart Error
HARD fault - The serial port used for Web
Enter to Reboot or
TLC communications is not working.
Power Down to Clear
Trace Uart Error
HARD fault - The serial port used for loader
Enter to Reboot or
traces communications is not working.
Power Down to Clear
Barcode Uart Error
HARD fault - The serial port used for bar
Enter to Reboot or
code scanner communications is not working
Power Down to Clear
DRV 1 ComOpen Fail
HARD fault - The serial port used for LTO
Enter to Reboot or
drive communications failed the loopback
Power Down to Clear
register test.
Drv Baud Check
HARD fault - The serial port used for drive
Error
communications is present but the loader
Enter to Reboot or
could not connect to the drive at any baud
Power Down to Clear
rate.
No Drives Attached
SOFT fault - A front panel load or unload
Press Enter to Clear
command could not find any tapes to move.
All drives and slots are empty.
All Drvs/Slots Empty
SOFT fault - A front panel load or unload
Press Enter to Clear
command detected all drives and slots full.
No place to put a cartridge.
All Drvs/Slots Full
SOFT fault - The magazine was removed
Press Enter to Clear
when a front panel load or unload command
was issued.
No Slots Installed
Soft Fault
Press Enter to Clear
No Drives Attached
SOFT fault - The magazine was removed
Press Enter to Clear
when a front panel load or unload command
was issued.
All Slots Empty
SOFT fault - A front panel cleaning
Press Enter to Clear
command was issued while the magazine
was removed.
All Drives Full
SOFT fault - The LTO drive was already
Press Enter to Clear
loaded when a front panel cleaning command
was issued.
DRV Timeout Error
SOFT fault - DRV Timeout Error (unused in
LTO).
Press Enter to Clear
DRV Already Loaded
SOFT fault - DRV Already Loaded (unused in
LTO).
Press Enter to Clear
C, D, G
C, D, G
C, D, G
C, D, G
C, D, G
F
F
F
F
F
F
F
F
F
Need help?
Do you have a question about the PowerLoader and is the answer not in the manual?