Configuration Options Descriptions; Set Data Format; Set Scsi - Overland Storage PowerLoader User & Installation Manual

C O D
ONFIGURATION PTIONS ESCRIPTIONS
4) Press the L or M buttons to scroll to the option you want to change. For this example, scroll to
Set SCSI and press Enter. The Set SCSI Submenu displays:
5) To change the SDLT Bus ID, scroll to SDLT Bus ID and press Enter.
6) From line 4, scroll through the options and press Enter to select the number option you want.
7) Press the Escape button several times to return to the Set SCSI Options submenu.
8) Repeat this procedure for each configuration option you want to change.

Configuration Options Descriptions

You can change the following options on the Configure Submenu:
NOTE: Configuration Options defaults are listed below in

Set Data Format

This setting allows you to set the data format and enable or disable data compression. This
setting applies to the next or the currently, loaded cartridge only. An unload command returns
to the default. This setting does not display, the format of the loaded tape. Revert to Show
Status Menu for this purpose.

Set SCSI

Allows you to enable or disable the robotics SCSI bus parity checking, and set the SCSI
addresses of the drives and the robotics.
u
2-6 Installation
Set Data Format Set Data Format Set Data Format Set Data Format
u u u u
Set SCSI Set SCSI
Set SCSI Set SCSI
Set Library Mode Set Library Mode
Set Library Mode Set Library Mode
Set Element Base Set Element Base Set Element Base Set Element Base
Figure 2-5. Configure Submenu Screen
Library Parity: Library Parity: Library Parity: Library Parity:
✱ ✱ ✱ ✱ Enabled Enabled
Enabled Enabled
Library Bus ID: Library Bus ID: Library Bus ID: Library Bus ID:
✱ ✱ ✱ ✱ 6 6 6 6
Figure 2-6. Set SCSI Submenu Screen
i i i i
i i i i
Table 2-3
.