Table of Contents
Advertisement
56
NetWare 5.0 – Boot Controller
Use the following procedure to install support for a SmartRAID VI
controller during installation of NetWare 5. The controller should be
installed at the beginning of the procedure so that it can be detected by
the install routine.
1.
Install the DPT controller as the primary controller and attach
the disk drives. You can use SMOR to create disk arrays or Hot
Spare drives when you boot the system.
2.
Install and configure a secondary controller (non-I2O SCSI or
IDE) for the CD-ROM drive and any other storage devices such as
a tape drive.
3.
Create a directory on the C: drive named NWUPDATE.
4.
Insert the DPT NetWare diskette into the floppy disk drive.
5.
Copy A:\NW5 to C:\NWUPDATE.
6.
Start the NetWare installation program from the CD-ROM. Use
the Custom Installation option.
7.
On the Server Drivers - Summary menu, highlight Disk and
CDROM Drivers and press Enter.
When prompted choose I2OPCI.NLM and BKSTROSM.HAM as disk
drivers.
8.
Complete the NetWare installation according to the Novell
documentation.
Verify that I2OPCI.NLM is listed after BKSTROSM.HAM in your
STARTUP.NCF file.
9.
Install the latest support pack for NetWare 5.0.
NOTE
Installing a NetWare Support Pack will overwrite the I
drivers supplied by DPT. If you encounter problems after
installing the Support Pack, you can restore the DPT files by
copying them from the DPT NetWare diskette.
Software Installation
O
2
Advertisement
Table of Contents
