Table of Contents
Advertisement
42
Additionally, the Microsoft I
inherently support bootable controllers. If you want to boot the
SmartRAID VI controller with the Microsoft I
1.
Install Windows NT 4.0 with the DPT Windows NT 4.0 miniport
driver.
2.
After Windows NT is installed, remove the DPT Windows NT 4.0
miniport driver from the SCSI Adapters list.
3.
Install the Microsoft Windows NT OSM I
ROM on the SmartRAID VI controller will manage the Windows
NT 4.0 boot process up to the point where the Microsoft I
loads.
Windows 95/98
The DPT SmartRAID VI driver for Windows 95/98 provides support for
both disk drives and other devices, such as CD-ROMs and scanners.
There are several driver installation scenarios under Windows 95/98:
•
Installing the SmartRAID VI controller into a new system, then
installing Windows 98
•
Installing a SmartRAID VI controller into a new system, then
installing Windows 95
•
Upgrading an existing Windows 95 system to Windows 98
•
Adding a SmartRAID VI controller to an existing Windows 95/98
system
•
Upgrading Windows 3.1 to Windows 95 and installing a
SmartRAID VI controller
Each of these cases requires a slightly different procedure.
Software Installation
O OSM driver for Windows NT does not
2
O OSM, do the following:
2
O driver. The I
2
O BIOS
2
O OSM
2
Advertisement
Table of Contents
