Table of Contents
Advertisement
2.
When prompted for the SCO BTLD diskette (DPT volume), insert
the DPT BTLD diskette into the floppy drive.
3.
Insert the N1 or Boot disk again when prompted.
4.
If installing SCO 3.2V4.2 or ODT3.0, insert the N2 diskette when
prompted. During the Hardware Roster, the following line should
appear:
If you are installing SCO UNIX 3.2V5.0.x., during the Hardware
Roster, the following line should appear:
5.
Continue the installation according to the SCO documentation.
NOTE
If you are installing from tape or CD-ROM, SCO UNIX 3.2V4.2
expects to find the tape at Controller 0, SCSI ID 2, LUN 0 and
the CD-ROM at Controller 0, SCSI ID 5, LUN 0.
SCO OpenServer 5 will locate the tape or CD-ROM at any valid
SCSI address.
Adding to an Existing SCO UNIX 3.2V4.2 or
OpenServer 5 System
When adding a DPT controller to an existing SCO UNIX configuration,
perform the following steps.
1.
Install the DPT controller.
2.
Boot SCO UNIX.
3.
After SCO UNIX has booted, place the DPT SCO driver diskette
in the floppy drive.
4.
Run the installpkg utility.
SCO UNIX will read the diskette and prompt you to enter the
package name to be installed. Enter dpti4 for SCO UNIX 3.2V4.2
or ODT 3.0, and dpti5 for SCO OpenServer 5.
5.
Rebuild the kernel after the package is installed. Shutdown and
reboot the system to install the new kernel and add devices on the
controller.
Software Installation
% adapter type=dpti ha=0 id=7 channel=0, PCI
% adapter type=dpti ha=0 id=7, PCI
49
Advertisement
Table of Contents
