Installing Software on a
Novell NetWare Server
This chapter explains how to install the software required to use the
AAA-13xSA RAID card in a Novell NetWare (NetWare 3.12 and
4.11) server.
Before installing the software, make sure the AAA-13xSA RAID card
is already installed. If you plan to boot from an array, make sure the
array is already created. To install all of the software, you must com-
plete the following in the order presented:
Install the cda1000.dsk driver for Novell NetWare
Install the TIRPC Communications Module
Install the Adaptec CI/O Management Software for Novell
NetWare
Once all software is installed, refer to the Adaptec CI/O Management
Software User's Guide for instructions on adding, deleting, and man-
aging your arrays from the server console.
Note:
If your server has an additional Adaptec AIC
device (for example, AHA
adapter) installed, the NetWare driver for these adapters
must be from the Adaptec 7800 Family Manager Set 2.10 or
higher. Ultra2 SCSI host adapters require v3.01 or higher of
the Family Manager Set.
®
-2940 or AHA-3940 host
5
™
-78xx
5-1