Table of Contents
Advertisement
50
SCO UnixWare 7
1.
Install the SmartRAID VI controller as in Chapter 3, "Controller
Configuration and Installation".
2.
Obtain the latest I
should be PTF7067E or higher).
3.
Copy or download the ptf file to the /tmp directory. Use the pkgadd
utility to install the I
4.
Follow the on-screen prompts to install the SCO UnixWare I
supplement.
5.
Shutdown and reboot the system.
NOTE
Upon reboot several WARNING messages may appear and
scroll off the screen quickly. These will not occur after
"diskadd" is run and can be ignored.
6.
Use the diskadd utility to add drives or arrays that are attached to
a SmartRAID VI controller.
Run the sdiconfig –l utility in a terminal window or non-GUI
screen. This will list all controllers recognized by the operating
system and any attached devices. Use this listing to determine the
proper ID to use for the diskadd utility.
The diskadd command to add devices on a secondary controller is:
Where:
See the diskadd(1M) man page for more information.
For example, if a new drive or array is on the DPT controller, on channel
0, with an ID of 0, the command would be:
Software Installation
pkgadd –d /tmp/ptf7067e.s
diskadd c C b B t T d D
C
specifies the ID for the controller in the system.
B
is the controller bus number (from 0 – 7) to which the disks
are attached.
T
is the target controller number (ID). The value of T can be
0 – 31.
D
is the Logical Unit Number (LUN) of the disk device, from
0 – 31.
diskadd c1b0t0d0
O supplement for UnixWare 7 from SCO (it
2
O supplement by entering the command:
2
O
2
Advertisement
Table of Contents
