Table of Contents
Advertisement
44
13. Select Have Disk and insert the DPT Windows 95/98 diskette
when prompted. The system will then reboot back into
Windows 98.
NOTE
If more than one DPT SmartRAID VI controller is installed in
the computer, repeat steps 12 and 13 for each controller.
Device Manager (in Control Panel/System) should now show a DPT I2O
SCSI Host Adapter in the SCSI Controllers section.
You can use a text editor to remove the following entries from your
CONFIG.SYS file:
You can also use a text editor to remove the MSCDEX entry from your
AUTOEXEC.BAT file. When you complete the installation procedure these
CONFIG.SYS and AUTOEXEC.BAT file entries are no longer needed.
Installing Windows 95 (OEM SR2 – Version 950b)
This section describes the steps to install Windows 95 (OEM SR2
Version) on one disk drive or array group using a SmartRAID VI
controller. Ensure that your disk drives, arrays, CD-ROM drive, and any
other SCSI devices attached to the controller are recognized by SMOR
before proceeding.
Do the following to install Windows 95 (OEM SR2 Version) with a
SmartRAID VI controller:
1.
Boot DOS from a bootable DOS diskette.
2.
Run FDISK and create a Primary DOS Partition of an appropriate
size.
3.
Mark the Primary DOS Partition Active.
4.
Reboot the system from the DOS diskette.
5.
Perform a system format (FORMAT C: /S).
6.
Run the SETUPCD.EXE program on the DPT diskette. This
program will create an AUTOEXEC.BAT and CONFIG.SYS to
support your CD-ROM drive.
7.
Ensure that the MSCDEX.EXE program is in your boot path or
the root directory of the C: drive.
8.
Reboot the system from the C: drive.
9.
Insert the Windows 95 OEM SR2 CD in the CD-ROM drive.
10. Enter the drive letter assigned to the CD-ROM and run SETUP
(for example, D:\SETUP).
Software Installation
DEVICE=I2ODDL.SYS
DEVICE=DPTCDROM.SYS
Advertisement
Table of Contents
