Installing The Software Driver For Sco Unixware - Adaptec AAA-130U2 Installation And Hardware Manual

Installing the Software
Driver for SCO UnixWare
In this Chapter
Installing the Array1000U2 Driver for UnixWare
This chapter explains how to install the AAA-131U2/133U2 soft-
ware driver ( cda1000 ) for SCO UnixWare 7.0. Before installing the
driver, make sure you have completed the following:
Installed the AAA-131U2/133U2 in your system.
(See Chapter 2)
Created the first array using the ARRAYCONFIG U2 utility, if
you plan to boot from an array. (See Chapter 3)
Once UnixWare and the driver are installed, install Adaptec CI/O
Management Software from the server 's X Window (CI/O is
required for array management in order to provide the proper level
of fault tolerance and event notification). Refer to the Adaptec CI/O
Management Software User's Guide for instructions on installing and
using the software.
ç
6-2
6-1