Arcconf Driverupdate; Arcconf Failover; Arcconf Getconfig - Adaptec Command Line Utility User Manual

LogicalDrive|JBOD ALL deletes all logical drives or JBODs.
Noprompt is an optional parameter that suppresses alert messages.
Examples
ARCCONF DELETE 1 LOGICALDRIVE 1 2 3
ARCCONF DELETE 1 JBOD ALL

arcconf driverupdate

Updates Windows device drivers. When given a directory name, it will attempt to update a
driver to the version found in the given directory.
Note:
This command is available only on Windows systems.
Syntax
ARCCONF DRIVERUPDATE <DirName>
Parameters
Driverupdate <DirName> is the directory path containing the driver that you want to update.
Example
ARCCONF DRIVERUPDATE C:\WINDOWSALL

arcconf failover

Turns automatic failover on and off.
Syntax
ARCCONF FAILOVER <Controller#> <on|off>
Parameters
Controller# is the controller number.
On turns the controller failover mode on.
Off turns the controller failover mode off.
Example
ARCCONF FAILOVER 1 ON

arcconf getconfig

Lists information about the controllers, logical drives, and physical devices. This information
can include (but is not limited to) the following items:
Controller type
●
BIOS, boot block, device driver, and firmware versions
●
Logical drive status, RAID level and size,
●
MaxIQ cache status (enabled/disabled), cache policy (low, medium, high), and read/write
●
balance
Device type, device ID, presence of PFA, SSD status (SSD or not, part of MaxIQ pool,
●
MaxIQ pool compatibility)
Chapter 2: Using the Command Line Utility
17
●