Set Led Display Connection - RGBlink VENUS X1 User Manual

6. System Setup and Operation

Set LED Display Connection

Set LED Display Connection
VENUS X1 can realize three connection as follows connecting the Port D or Port U of one
sending card to LED screen, connecting the both Port D and Port U of one sending card to
LED screen, connecting the Port D and Port U of two sending cards to LED screen (PORT
A or PORT B is for Colorlight, and PORT D or PORT U is for Linsn). The following are the
detailed operation steps of the three connection.
1. Connect the Port D or Port U of One Sending Card to LED Screen
Here we take No.1 sending card, port U1 for example. (Note: No.1 sending card
corresponding to port D1 and port U1, No.2 sending card corresponding to port D2 and
port U2.
(1) First, make sure that the device is in normal operation.
(2) Choose the input source, for example, DVI.
(3) Connect the cable to Port U1.
(4) Turn the knob, and select <LED MANAGEMENT>:
(5) Push the knob to confirm, turn the knob, select <SENDING CARD TYPE> in <QUICK
CONNECTION> option, push the knob to confirm, turn the knob, select the sending
card type, for example, select Linsn (VENUS X1 supports Linsn and Colorlight sender
card, for Nova sender card, it only support brightness and Gamma adjustment). Shown
as follows:
VENUS X1
SYSTEM
->LED MANAGEMENT
LANGUAGE/语言
FACTORY RESET
->QUICK CONNECTION
ADVANCED
User Manual
>>
>>
ENG
>>
>>
>>
99