There Is Flash Point When Output To The Led Screen; Change The Dvi Cable; Change The Dvi Output Port - RGBlink VENUS X1 User Manual

7. Common Questions and Solutions
video processors. Choose fixed split or normal split, and open the split
function.
1. FIXED SPLIT: Set the horizontal split and vertical split according to
actual need.
2. NORMAL SPLIT: Set the H TOTAL, V TOTAL, H POS, V POS, H SIZE
and V SIZE according to actual need. User can do the quick split only
need setting three groups of the parameters.

There is Flash Point when Output to the LED Screen

Change the DVI Cable

There is flash point on LED display when input sending card. This is
because the DVI cable quality of good and bad are intermingled. Please
change the DVI cable and test again.

Change the DVI Output Port

The DVI output port is loose or oxidation due to plug and pull frequently or
long time no use, which may cause the signal attenuation. There are two
DVI output ports on VENUS X1, please change to the other DVI output port
and test again.
VENUS X1 User Manual 136