Set Led Display Connection - RGBlink VENUS X1 Quick Start Manual

Set LED Display Connection

VENUS X1 can realize three connection as follows connecting the Port D or Port U of one sending card
to LED screen, connecting the both Port D and Port U of one sending card to LED screen, connecting
the Port D and Port U of two sending cards to LED screen (PORT A or PORT B is for Colorlight, and
PORT D or PORT U is for Linsn). The following are the detailed operation steps of the three connection.
1. Connect the Port D or Port U of One Sending Card to LED Screen
Here we take No.1 sending card, port U1 for example. (Note: No.1 sending card corresponding to
port D1 and port U1, No.2 sending card corresponding to port D2 and port U2.
(1) First, make sure that the device is in normal operation.
(2) Choose the input source, for example, DVI.
(3) Connect the cable to Port U1.
(4) Turn the knob, and select <LED MANAGEMENT>:
(5) Push the knob to confirm, turn the knob, select <SENDING CARD TYPE> in <QUICK
CONNECTION> option, push the knob to confirm, turn the knob, select the sending card type, for
example, select Linsn (VENUS X1 supports Linsn and Colorlight sender card, for Nova sender card,
it only support brightness and Gamma adjustment). Shown as follows:
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
SYSTEM
->LED MANAGEMENT
LANGUAGE/语言
FACTORY RESET
->QUICK CONNECTION
ADVANCED
>>
>>
ENG
>>
>>
>>
8
Tel: 00865925771197
Email: sales@rgblink.com
Fax: 00865925788216
http://www.rgblink.cn