RGBlink VENUS X1 User Manual page 104

6. System Setup and Operation
Set LED Display Connection
f. Turn the knob, and choose <Offset (A/B) Y>, push the knob to confirm. Turn the knob,
set Offset (A/B) Y as 240 (Note: Offset (A/B) Y=VERTICAL CARD×HEIGHT, in the
previous part, we set vertical card as 2 and height as 120). Shown as follows:
g. Turn the knob, and choose <CONNECT CARD TYPE>, shown as follows:
Choose the connection mode, the setting is same as Port U1. Then connection of
both the Port D and Port U of One Sending Card to LED Screen is finished.
Rendering is as follows:
VENUS X1
SENDING CARD SET
->RECEIVING CARD SET
->CHOOSE CABLE
HORIZONTAL CARD
VERTICAL CARD
WIDTH
HEIGHT
Offset (A/B) X
->Offset (A/B) Y
CONNECT CARD TYPE
HEIGHT
Offset (A/B) X
Offset (A/B) Y
->CONNECT CARD TYPE
User Manual
>>
>>
PORT D
3
2
120
120
0
240
>>
120
0
240
>>
104