Set Led Display Connection - RGBlink VENUS X1 Quick Start Manual

Enable or disable the swap window function.
Alpha:
Image transparency setting, the adjustment range is 0 to 16.

Set LED Display Connection

VENUS X1 can realize three connection as follows connecting the Port D or Port U of one sending card to LED
screen, connecting the both Port D and Port U of one sending card to LED screen, connecting the Port D and
Port U of two sending cards to LED screen (PORT A or PORT B is for Colorlight, and PORT D or PORT U is for
Linsn). The following are the detailed operation steps of the three connection.
1. Connect the Port D or Port U of One Sending Card to LED Screen
Here we take No.1 sending card, port U1 for example. (Note: No.1 sending card corresponding to port D1
and port U1, No.2 sending card corresponding to port D2 and port U2.
(1) First, make sure that the device is in normal operation.
(2) Select the input source, for example, DVI.
(3) Connect the cable to Port U1.
(4) Turn the knob, and select <LED MANAGEMENT>:
(5) Push the knob to confirm, turn the knob, select <SENDING CARD TYPE> in <QUICK CONNECTION> option,
push the knob to confirm, turn the rotary knob, select the sending card type, for example, select Linsn
(VENUS X1 supports Linsn and Colorlight sender card, for Nova sender card, it only support brightness and
Gamma adjustment). Shown as follows:
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
SYSTEM
->LED MANAGEMENT
LANGUAGE/语言
FACTORY RESET
->QUICK CONNECTION
ADVANCED
*SENDING CARD TYPE
SENDING CARD NO.
OUTPUT FORMAT
QUICK CONNECTION
>>
>>
ENG
>>
>>
>>
LINSN
No.2
>>
>>
8
Tel: 00865925771197
Email: sales@rgblink.com
Fax: 00865925788216
http://www.rgblink.cn