User Pin [27]; Enable User Pin - Siemens SITRANS Series Operating Instructions Manual

Parameter assignment
9.2 Parameter assignment over device with display
3. Enter the digits of the PUK:
– Use the
– Use the
– Use the
The complete PUK is shown on the top line of the display.
4. When the PUK is complete, use the
Result
● If you have entered the correct PUK, the message "NEW PIN - 2457" appears.
The user PIN has been reset to the factory setting 2457.
● If the PUK was not correctly entered, the message "FAILD" appears.
Then repeat the described procedure.
9.2.25

User PIN [27]

Used to enable or disable the user PIN.
Setting range:
Factory setting:
When user PIN is enabled, the measured values and parameters are read-only.
● To change the parameters and use the device functions, the user PIN must be input.
The user PIN 2457 is factory preset in the device.
Note
Write protection is automatically enabled 10 minutes after the last button operation.
● Enter the user PIN.
9.2.25.1

Enable user PIN

Requirement
The User PIN is disabled.
134
or button to change.
button to confirm.
button to delete.
ON
OFF
User PIN disabled
button to confirm.
Enable user PIN
Disable user PIN
Operating Instructions, 06/2018, A5E44852162-AA
SITRANS P320/P420 (mA/HART)