Password Page - Comtrol DeviceMaster PNIO 2000 Series User Manual

IPv4
Use DHCP
Use PLC assigned
Use static config
below

Password Page

DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
Option
Configures the DeviceMaster to use DHCPv4 mode.
See your System Administrator to acquire a unique reserved IPv4
address if you are using DHCP. They will need the MAC address of
the unit to provide you with an IPv4 address.
The Use PLC assigned radio box is for information only. Use
an IP Address via IO Controller
the TIA Portal project. If you select the Use PLC assigned option and
reboot the DeviceMaster, the gateway will start with the 0.0.0.0 IP
address and the web interface will not work.
Configures the DeviceMaster with the static IPv4 address
information that you provide in the Address, Subnet Mask, and
Default Gateway fields below.
The DeviceMaster is shipped from the factory with the following
default IPv4 network settings:
• IPv4 address = 192.168.250.250
• IPv4 Netmask = 255.255.0.0
• IPv4 Gateway address = 192.168.250.1
You can easily set up a password to secure the DeviceMaster.
Note: There is no password set from the factory.
Use the following information to configure a password for this DeviceMaster.
1. Click Network | Password.
2. If changing an existing password, enter that password in the Old Password
field.
3. Enter a new password and enter the confirmation password.
4. Click the Save button.
When anyone attempts to log into the DeviceMaster, you must enter the following:
• admin for the username
• The configured password for the password
Description
on Page 74 to set the IP address in
Network Menu
Assigning
Network Menu - 105