Changing The Bootloader Timeout - Comtrol DeviceMaster PNIO 2000 Series User Manual

Changing the Bootloader Timeout

DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
6. Select LOCAL for the Detection Type.
7. Enter the MAC address or network information.
Note: A MAC address label is attached to all DeviceMaster units. The first
three pairs of digits start with 00 C0 4E.
8. Optionally, enter the serial number in the Serial Number list box.
9. Click Ok.
10. If necessary, click Refresh for the new DeviceMaster to display in the Device
Tree or Device List panes. The DeviceMaster shows OFF-LINE if it is not
attached to the network or if an incorrect IP address was entered.
1. If necessary, use your browser to access the DeviceMaster using the IP
address.
2. Click Network.
3. Enter 45 in the Boot Timeout field and click Save.
Note: You should return the Bootloader Timeout value back to 15 seconds after
you upload the firmware.
Managing the DeviceMaster
Managing the DeviceMaster - 131