Rebooting the DeviceMaster
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
Managing the DeviceMaster
This section discusses the following DeviceMaster maintenance procedures:
•
Rebooting the DeviceMaster
•
•
Note: You can configure the network addresses for multiple DeviceMasters,
configure common settings for the DeviceMasters, and save the settings
to a configuration file that you can use to load settings up to all or
selected DeviceMasters.
•
•
Bootloader version and downloading the latest Bootloader
•
•
Page 135
Note: You can optionally refer to
perform procedures at the RedBoot level.
There are many ways to reboot the DeviceMaster.
Method
Right-click the DeviceMaster or DeviceMasters in the Device
List pane, click Advanced >Reboot and then Yes.
PortVision DX
Note: If security has been enabled in the web page, you will
System | Reboot: You have 10 seconds to Cancel before the
Web page
DeviceMaster automatically reboots. Optionally, you can click
Reboot Now.
Telnet
Type reset.
DeviceMaster DIN rail models have a Reset/Restore switch.
•
If the Reset/Restore switch is depressed for less than 2
DeviceMaster
seconds, the DeviceMaster reboots.
DIN Rail Models
•
If the Reset/Restore switch is depressed for greater than
approximately 5 seconds it restores the DeviceMaster to
the factory default values.
on Page 132, which also discusses checking the
RedBoot Procedures
Procedure
need to reboot the DeviceMaster in the web page.
on Page 139 if you want to
Managing the DeviceMaster - 127