Assigning An Ip Address Statically; Assigning Ip Address Statically Using The Web Page - Comtrol DeviceMaster PNIO 2000 Series User Manual

Assigning an IP
Address Statically
Assigning IP Address
Statically Using the
Web Page
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
IP addresses can be assigned statically using one of the following methods:
• Embedded web interface (or PortVision DX)
• Assign IP address function of TIA Portal on-line access
You can use the following procedure to configure a static IP address using the web
interface.
1. Open a web browser and enter the DeviceMaster gateway address.
2. Click Network | Configuration.
3. Select the Use static config below radio button.
4. Enter an IP address, subnet mask, and gateway address.
5. Click the Save button.
A reboot is required for the new IP address to take effect.
6. Click System | Reboot and the DeviceMaster will reboot in 10 seconds or you
can click on the Reboot Now button to reboot immediately.
Configuring the DeviceMaster in TIA Portal
Configuring the DeviceMaster in TIA Portal - 71