Table of Contents
Advertisement
Hardware Installation
Replacing Hardware
22 - Hardware Installation
Use this procedure to replace hardware.
1. Remove the old unit and attach a new or spare DeviceMaster.
2. Connect the new DeviceMaster to the network hub or server NIC.
3. Apply power to the new DeviceMaster and verify that it passes the power on
self-test.
4. Program the IP address of the new DeviceMaster.
5. If necessary, upload the latest protocol firmware.
6. Configure any ports as necessary to match the previous unit or upload
configuration files from PortVision DX.
7. Transfer all cabling from the old DeviceMaster to the new DeviceMaster.
8. It is not necessary to shut down and restart the host PC.
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
Advertisement
Table of Contents
Troubleshooting
