Changing Keys And Certificates; Profinet Io Page - Comtrol DeviceMaster PNIO 2000 Series User Manual

Changing Keys and
Certificates

PROFINET IO Page

DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
Use the following steps to update security keys and certificates in the
DeviceMaster.
1. Click the Network | Keys/Cert.
2. Click Browse to locate the key or certificate file, highlight the file, and click
Open.
Refer to the Keys/Certs Page
3. Click Upload when you return to the Key and Certificate Management area.
The key or certificate notation changes from factory or none to User when the
DeviceMaster is secure.
Changes will not take effect until the DeviceMaster is rebooted.
4. Click System | Reboot to reboot the DeviceMaster.
The following table explains the options on this page.
Miscellaneous
Setting
Enable channel- If you enable this feature, the DeviceMaster can notify the IO
specific diagnostics controller via alarm when an oversize packet is available.
Once enabled, the DeviceMaster sends a diagnostic alarm to
the IO controller when an oversize packet is saved. The alarm
is a channel-specific diagnostic alarm with an error type 4096
(16#1000).
Using the slot information associated with the alarm, the IO
controller can start a record data read instruction to retrieve
the saved packet for a certain port/device. After the packet is
read, the DeviceMaster clears the alarm automatically.
on Page 107 subsection for detailed information.
Description
Network Menu
Network Menu - 109