Resetting The Devicemaster; Configuring Passwords - Comtrol DeviceMaster PNIO 2000 Series User Manual

Table of Contents

RedBoot Procedures

Resetting the DeviceMaster

144 - RedBoot Procedures

When you have completed your tasks in RedBoot, you must enter a reset command

at the RedBoot> prompt for the DeviceMaster to begin operation.

Note: The

LEDs

on the DeviceMaster will go through the power up sequence. The

DeviceMaster has completed its reset cycle when the Status LED is lit and it

stops flashing.

RedBoot> dis

Loading disabled

RedBoot> reset

This section discusses how to configure a password for the web and telnet server.

Use the following procedure to establish the DeviceMaster password for the Web

and telnet server. Establishing a password prevents unauthorized changes to the

DeviceMaster configuration.

1. Establish communications with the DeviceMaster using the serial (Page 140)

or telnet method (Page 141).

2. Type password [your_password] and press Enter.

Note: If you forget your password, you can reprogram the password using the

serial method which bypasses the password.

Note: The Bootloader version on your DeviceMaster may be different than the

version displayed in this graphic.

See the auth command in the

want to set up Web browser authentication.

RedBoot Command Overview

DeviceMaster PNIO | UP User Guide: 2000639 Rev. A

on Page 145, if you

Table of Contents