Table of Contents
Advertisement
Installing the GSD File
Adding the DeviceMaster
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
Configuring the DeviceMaster in TIA
Portal
This section contains the following topics;
•
Installing the GSD File
•
Adding the DeviceMaster
•
IP Address Assignment
•
Device Name Assignment
•
Establishing A PROFINET IO Connection
•
Status LED Behavior
•
Configuring IO Modules
Use the following steps to install the DeviceMaster GSD file into TIA Portal.
1. Open the DeviceMaster home page, download and unzip the GSDML-V2.32-
Comtrol-DM-yyyymmdd.zip file to a working directory.
Note: If you have not previously configured an IP address using PortVision
DX, the default IP address is 192.168.250.250 with a subnet mask of
255.255.0.0. If you do not use PortVision DX to program the IP address,
you may need to change your system IP address to initially
communicate with the Comtrol device.
2. Open TIA Portal V13 and click Project View.
3. Use the Options | Install general station description file (GSD) menu to install the
GSD file.
Use these steps to add the DeviceMaster.
1. From the Hardware catalog, under Other field devices | PROFINET IO | Gateway |
Comtrol Corporation | Comtrol DeviceMaster, select the model corresponding to
your device, and drag it into the Network view area.
Use the following table to choose the correct model from the hardware catalog
in TIA Portal for your device. The number of serial ports (1P, 2P or 4P) and
number of Ethernet ports (1E or 2E) must match your device. The form factor
(panel vs DIN rail), power supply, or the type of serial port connectors (DB9 vs
terminal blocks), does not matter.
DeviceMaster 1-Port 5-30VDC
DeviceMaster PNIO-2101
DeviceMaster PNIO-2201
DeviceMaster UP DB9M 2-Port 1E (PNIO-2102)
DeviceMaster UP 2-Port 1E (PNIO-2202)
on Page 69
on Page 69
on Page 70
on Page 75
on Page 78
on Page 79
on Page 79
Description
Configuring the DeviceMaster in TIA Portal - 69
GSD Model
DM PNIO 1P1E
DM PNIO 2P1E
Advertisement
Table of Contents
Troubleshooting
