Assigning An Ip Address Via Io Controller - Comtrol DeviceMaster PNIO 2000 Series User Manual

Configuring the DeviceMaster in TIA Portal
Assigning an IP
Address via IO
Controller
74 - Configuring the DeviceMaster in TIA Portal
4. Click System | Reboot and the DeviceMaster will reboot in 10 seconds or you
can click on the Reboot Now button to reboot immediately.
Once rebooted, the gateway attempts to obtain an IP address from a DHCP
server. You can use PortVision DX to find out the new IP address of the
gateway or do a network scan in TIA Portal.
Notes:
• DHCP can only be enabled or disabled via the web interface. Certain versions
of SIMATIC STEP 7 have a function to enable DHCP if a PROFINET IO
device supports it. However, the DeviceMaster does not support enabling
DHCP through STEP 7.
• Similar to static IP address assignment, when DHCP is enabled, you will need
to configure the TIA Portal project not to set IP address in project. Refer to
Configuring TIA Portal Project Not to Set IP Address
address is set directly at the device option.
An IO controller can assign IP address to the DeviceMaster via DCP. The IO
controller and the DeviceMaster gateway have to be on the same subnet.
1. In TIA Portal, double-click the DeviceMaster module to open the Device View.
2. On the Properties | General tab, click the PROFINET interface [X1] | Ethernet
addresses, which opens the Ethernet addresses properties window.
3. Make sure the Use IP protocol check box is checked and the Set IP address in
the project radio button is selected.
4. Manually enter the IP address for the DeviceMaster gateway.
5. Compile and download the project.
The new IP configuration takes effect when a connection is established
between the DeviceMaster and the IO controller. A reboot is not required.
Note: The Use PLC assigned radio box on the Network | Configuration page (Page
73) is for information only. Use the above steps to set the IP address in
TIA Portal project. If you select the Use PLC assigned option and reboot
the DeviceMaster, the gateway will start with the 0.0.0.0 IP address and
on Page 73 to set the IP
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A