Assigning Ip Address Statically Using Tia Portal - Comtrol DeviceMaster PNIO 2000 Series User Manual

Configuring the DeviceMaster in TIA Portal
Assigning IP Address
Statically Using TIA
Portal
72 - Configuring the DeviceMaster in TIA Portal
You can also use the following procedure to configure a static IP address using TIA
Portal.
1. Double-click Project tree
| Online access | Your
Ethernet Adapter |
Accessible device
[192.168.250.250] | Online
& diagnostics to open
the Online access
window, where Your
Ethernet Adapter is the
name of your
networking interface,
and Accessible device
[192.168.250.250] is the
gateway, as shown in
this figure (right).
2. Click Functions | Assign
IP address and enter the
desired IP
configurations, as
shown in the next screen shot.
3. Click the Assign IP address button and then the IP configuration is assigned to
the gateway.
You can access the gateway using the new IP address immediately. A reboot is
not required.
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A