Using The Web Page To Update Software - Comtrol IO-Link Master Series Initial Installation And Configuration

6. You may notice that PortVision DX first displays a Firmware uploaded status message. After the
next PortVision DX polling cycle the status message displays ON-LINE.
7. Repeat the above steps for each image.

Using the Web Page to Update Software

Use the following procedure to update software on the IOLM using the IOLM web page.
1. Open your web browser and enter the IP address of the IOLM or highlight the IOLM in PortVision
DX and click the Webpage button.
2. Click Advanced | Software.
3. Click the UPDATE button that corresponds to the image that you want to upload.
4. Click the Browse... button.
5. Locate and highlight the file.
6. Click Open.
7. Click the Install button.
8. Click the CONTINUE button to the Update Image pop up message.
9. Wait the recommended time period before clicking the OK button to the In Progress message.
The Software page refreshes and displays that the version updated.
3/27/2015
Comtrol IO-Link Master Initial Installation and Configuration
P a g e | 14