Configuring Tia Portal Project Not To Set Ip Address; Assigning An Ip Address Via Dhcp - Comtrol DeviceMaster PNIO 2000 Series User Manual

Configuring TIA Portal
Project Not to Set IP
Address
Assigning an IP
Address via DHCP
DeviceMaster PNIO | UP User Guide: 2000639 Rev. A
When using static IP address assignment either through the web interface or TIA
Portal on-line access, you will need to configure the TIA Portal project not to set IP
address in project.
1. In TIA Portal, double-click the DeviceMaster module to open the Device View.
2. On the Properties | General tab, click the PROFINET interface [X1] | Ethernet
addresses, which opens the Ethernet addresses properties window.
3. Make sure the Use IP protocol check box is checked and the IP address is set
directly at the device radio button is selected, as shown in this figure.
The DeviceMaster gateway supports DHCP for IP address assignment. DHCP is
disabled by default. Use the following steps to enable DHCP.
1. Open a web browser and enter the DeviceMaster IP address. The default IP
address is 192.168.250.250.
2. Click Network | Configuration.
3. Select the Use DHCP radio button and click the Save button.
A reboot is required for the change to take effect.
Configuring the DeviceMaster in TIA Portal
Configuring the DeviceMaster in TIA Portal - 73