Preparation For Working Inside The Base Casting - Mecmesin Multitest 0.5d Service And Repair Manual

Multitest 0.5d, 1d & 2.5d
Service and Repair Manual

7. Preparation for working inside the base casting

2. Ensure that the test stand is switched-off
and disconnected from the mains supply
3. Support the test stand safely in an
inverted position
5. Remove base plate retained by 4-off
M4x12mm pan pozi taptite screws (into
the base casting) and 2-off M4x6mm pan
pozi screws into the rear panel
Number 022-005
Issue Number: 08
4. Remove 4-off rubber feet 22mm
dia x 10mm retained by
countersunk screws.
Page 7 of 58