Snmp Traps; Eme Command Changes In Release; Old Command Structure In Software Release 3.0.0; New Command Structure In Software Release 3.0.5 - 3Com 4007 Release Note

92 C 7: D
HAPTER OCUMENTATION

SNMP Traps

EME Command
Changes in
Release 3.0.5
C
HANGES
reset module all warm
excluding the EME, without executing diagnostics.
There are two topics that deal with SNMP traps:

EME Command Changes in Release 3.0.5

Setting SNMP Trap Destinations
This section reviews the EME interface command structure for SNMP
traps in software release 3.0.0, then shows the modifications that were
made in software release 3.0.5.

Old command structure in software release 3.0.0:

set eme
set snmp
show snmp
set trap_destination

New command structure in software release 3.0.5:

set snmp trap
show snmp extensions
trap
clear snmp trap
The display has been modified in this release. In version 3.0.0,
show eme
the command displayed Trap Receive status (ENABLED or
show eme
DISABLED). In version 3.0.5, Trap Receive status is shown under the
command.
snmp trap
— Use this command to reset all modules,
trap_receive
authentication_trap
authentication_trap extensions
<community> <ip>
destination <community>
filter authentication
link_state
topology_change disable/enable
receive disable/enable
disable/enable
disable/enable
<ip>
disable/enable
disable/enable
show